Smartwares Connected lamps using with remote control, wireless wall switch or transmitter installation
Using a LED bulb with a remote control, wireless wall switch or transmitter. To make use of the 'Smartwares XQ-Lite 868Mhz connected LED bulb ' in an optimal way, the bulb should always have power. This will not be the case when you turn off the bulb with a traditional switch. When you want to pair a connected LED bult with an established COCO and/or Smartwares remote control, wireless wall switch or sender (433Mhz sender) this is possible in combination with the HomeWizard. Use a 'Scene' for this. Follow the stept below to pair the Led bulb with the HomeWizard scene.
This instruction is assumed that the Smartwares XQ-Lite 868Mhz connected LED bulb is already installed.
- Press the button
'Menu' on the top left corner from the HomeWizard app.
- In the Menu select
'Manage Devices'.
- Ather this select press on the right corner
'Add device'
- Select
'Scene'
- Select and give it a
'Name' you want and press 'done'.
- Press 'Save' to to continue.
- Your now on the 'change setting' screen
- To add a Smartwares connected lamp you can add this by select
'Add device'.
- Select (already installed) Smartwares connected lamp
- 'On Behavior' Select what the switch does when the scene is turned on.
- 'Off Behavior' Select what the switch does when the scene is turned off
- Press 'Save' to go back
- If you add more devices its possible. Repeat the process again for the added device. If your done go to the next step.
- Click now on the button
'Code' .
- Press on 'Learn code from remote'
- Press a button on the remote control/ wall switch when this starts sending. (Read the instructions of the device)
- Press on 'Learn code from remote'
- If the code received on the HomeWizard-app is learning from the remote control wall switch successful.
Press '< Back' and than '
'Menu' to save the Scene.
- Select and give it a